6/11/2023 0 Comments Powerjog jx100 manual![]() Hold the reset button down for a few seconds. Replace any parts that need replacing, or is largeĮnough to trigger with a pencil eraser or Q-tip. ![]() Locate the console key and place the safety or reset key into 3) Run the software calibration for easy diagnostic and fix it. If the above does not clear the error code, please contact the nearest Dealer/Service Centerġ) reset the treadmil.2) adjust the speed sensor, see the diagram attached. Reinstalling the Safety Tether Key can also reset the display. Ensure that the Safety Tether Key is securely and properly installed onto the console or just Turn the treadmill on at the master power switch.Ĥ. WARNING: Ensure nothing is positioned near or under running belt which may possibly blockģ. Turn the treadmill off at the master power switch located near the motor housing. Ensure that you are clear of the running belt.Ģ. In the rare event of the treadmill displaying an error code ("E" followed by a number), simply resetġ. The treadmill will stop 16 seconds later after the console detects this ![]() Speed error (The treadmill running speed is 3.2 kph slower than the displayed The treadmill will stop immediately when the console detects this error. ![]() Speed error (The treadmill running speed is 3.2 kph faster than the displayed
0 Comments
Leave a Reply. |